●Same-day pickup available in most areas ●Background-checked local pros ●Serving all 50 states ●Donated or recycled whenever possible

Appliances & electronics

Residential service

Washer and dryer removal, out in one trip.

Front-loaders, top-loaders and stacked laundry pairs, carried out of the laundry room, basement or closet and hauled away for recycling. No dolly, no sore back.

Every pickup includes✓ Carried from any floor✓ Floors protected✓ Metal recycled
Background-checkedVetted local pros
Same-day availableNext-day almost everywhere
Basements & closetsTight laundry rooms handled
Appliance recyclingSteel and motors recovered

How it works

Three steps. No heavy lifting.

Tell us which units are going, choose your time, and the crew carries them out.

1

Tell us what's going

Washer, dryer or both, plus whether they're stacked or in a basement.

2

Pick a pickup window

Same-day in most areas when you book early. In-home or curbside.

3

Laundry room cleared

The crew carries the units out and sends them to recyclers.

What's included

Washer and dryer haul away, the easy way

Washers are heavy, awkward and usually sitting in the most cramped room of the house, often at the bottom of a basement staircase. JunkHaulAwayPros sends a crew that knows how to slide them out, maneuver them through tight doorways and get them on the truck without damaging floors, walls or railings.

  • Pulled out carefully. Units are walked out of tight nooks without scraping the floor.
  • Stacked pairs separated. Stacking kits are unhooked so each unit can be carried safely.
  • Basements and closets. Stairs, hallways and laundry closets are all part of the job.
  • Recycled, not dumped. Old units go to appliance and scrap metal recyclers.

Before pickup, shut off the water supply, disconnect the hoses and drain the washer. For gas dryers, have the gas line shut off and capped by a qualified person. Electric units just need to be unplugged, and the crew handles the rest.

Every laundry setup

Front-load, top-load and stacked units

Working or broken, new or decades old, the crew can remove it. Washers with leaks, dryers that won't heat and pairs that stopped matching after one was replaced are all fine.

Top-load washers

Classic agitator and high-efficiency models.

Front-load washers

Heavy drum washers with concrete counterweights.

Electric dryers

Unplugged and carried out with the vent disconnected.

Gas dryers

Removed once the gas line is shut off and capped.

Stacked pairs

Washer-dryer towers separated before carrying.

Laundry centers

All-in-one combo units from closets and condos.

Portable washers

Compact and apartment-size units.

Utility sinks

Freestanding laundry tubs from basements.

Clearing out the whole laundry room? Add the utility sink, old shelving and drying racks to the same pickup.

New laundry pair on the way?Book the old one's pickup for the same week.
Schedule washer and dryer pickup

Common reasons

When it's time for washer and dryer disposal

Most washers and dryers last around ten to fifteen years. These are the situations that usually lead to a laundry room pickup.

New set delivered

Delivery crews don't always take the old pair, or charge extra to do it.

Leaks or breakdowns

Failed pumps, bearings and control boards often aren't worth the repair bill.

Upgrading efficiency

Newer models use far less water and energy than units from a decade ago.

Selling the home

Buyers may not want the old units, or the laundry room needs to be empty for staging.

Basement remodel

Relocating the laundry room starts with removing the old appliances.

Rental upgrades

Landlords replace worn-out shared or in-unit laundry machines.

A closer look

Upgrading the laundry room

Washers and dryers are workhorses, but they don’t last forever. Most last around ten to fifteen years, and when one fails, many people replace both so the pair matches and works together efficiently. That leaves two large, heavy appliances that need to go.

Modern machines are also far more efficient. High-efficiency washers use significantly less water and energy, and newer dryers often include moisture sensors that prevent over-drying. Replacing an old pair can lower utility bills, and some utilities offer rebates for efficient models.

Before the old units are removed, it’s worth checking the hoses, valves and vents. Rubber hoses that are brittle or bulging should be replaced with the new machines, and dryer vents full of lint can be a fire hazard. Cleaning or replacing the vent at the same time is a good habit.

After pickup, washers and dryers go to appliance and scrap metal recyclers. Their steel cabinets, drums, motors and wiring are recovered and reused, keeping most of their weight out of the landfill.

On pickup day

What to expect when the crew arrives

Most washer and dryer pickups are wrapped up quickly once everything is disconnected. The crew protects the floors and walls, then carries each unit out to the truck. Here's how the visit goes.

1

A heads-up first

You'll know your arrival window ahead of time, so you can plan the rest of your day around it.

2

A quick walkthrough

Point out what's going and what's staying. The crew checks the easiest route out of the house.

3

Careful removal

Background-checked pros protect floors and walls, take items apart if needed and carry everything out.

4

Swept and sorted

The area gets a quick sweep, and everything is sorted for donation, recycling or disposal.

Two ways to book

In the laundry room or in the garage

Choose the pickup style that suits you. Since washers and dryers are heavy and awkward, most people let the crew carry them from where they sit.

In-home pickup

The crew comes in, slides the units out of place and carries them up the stairs and out the door. It's the safe choice for basement laundry rooms and front-load washers.

Curbside pickup

If the old units are already in the garage or on the driveway, leave them there and you don't need to be home when the crew arrives.

For curbside pickup, make sure the washer has been fully drained. Water left in the drum makes it heavier and can leak in the truck.

Steel cabinet & drumScrap metal recyclingMotor & wiringCopper recoveredCounterweightsSeparated and disposedPlastic partsRecycled or disposed

Responsible disposal

Where old washers and dryers go

Washers and dryers are mostly steel, which makes them some of the most recyclable items in a home. Units in good working order may be donated or resold to give them a longer life.

Broken units go to appliance and scrap metal recyclers. Steel cabinets, copper wiring and motors are recovered, while concrete counterweights and plastic parts are separated and disposed of properly.

Donate working unitsRecycle steel, copper and motorsDispose of only what’s left

Basements and closets

Tight laundry rooms and steep stairs

Laundry rooms tend to be squeezed into basements, hallway closets and mudrooms. Front-load washers can weigh close to 200 pounds, and getting one up a narrow basement staircase is where most DIY attempts go wrong.

Crews use proper technique and equipment to guide each unit out of its spot and up or down the stairs. Stacked pairs are separated first, doors may be removed for clearance, and floors and railings are protected the whole way.

If your laundry room is in a tight closet, up a flight of stairs or down a steep basement stairway, mention it when you book. A photo of the units and the route out helps the crew plan the job.

Book washer and dryer removal

Quick prep

Disconnect before we arrive

Washers and dryers need to be disconnected before pickup so the crew can get right to work. Here's what to take care of ahead of time.

  1. Shut off the water. Close both supply valves and disconnect the hoses from the washer.
  2. Drain the washer. Run a drain or spin cycle, or empty any standing water.
  3. Cap the gas line. Have a qualified person shut off and cap gas dryer lines.
  4. Empty and unplug. Remove clothes, lint and detergent, then unplug both units.

Weighing your options

Hauling it on your own?

Moving a washer or dryer takes two people, an appliance dolly and a truck, plus straps to keep it from tipping. Front-loaders are especially heavy because of the counterweights inside. Many trash programs require a separate appliance pickup, and some scrap yards and transfer stations only accept drop-offs at certain times or charge fees.

TaskDoing it yourselfWith a crew
Lifting & stairsYou and whoever you can recruitHandled by trained pros
TransportationBorrow or rent a truck or trailerTruck arrives with the crew
Finding a drop-offCall around about charities, landfills and city rulesSorted for donation, recycling or disposal
TimeOften half a day or moreUsually under an hour on site
RiskStrained backs, scuffed walls, dented doorframesFloors and walls protected

A light, compact dryer on the ground floor can be manageable on your own. For full-size pairs, basement laundry rooms or stacked units, a crew is the easier and safer choice.

Don't drag it up the stairs.Same-day and next-day appliance pickup in most areas.
Get your washer and dryer hauled away

Washer & Dryer Removal FAQ

Washer and dryer removal questions

Don't see your question? Send us a note and we'll get back to you within one business day.

Do I need to disconnect my washer and dryer before pickup?

Yes. Please shut off the water supply valves, disconnect the hoses and drain the washer before the crew arrives. Electric dryers just need to be unplugged, and the vent hose detached. Gas dryers need the gas line shut off and capped by a qualified person before removal, since the crew doesn't disconnect gas lines. Once everything is disconnected, the crew can start carrying the units out right away. Your delivery or installation team may be able to disconnect the old pair when they install the new one.

Will you take a washer or dryer that doesn't work?

Yes. Broken or working makes no difference. Washers that leak, won't spin or won't drain, and dryers that don't heat or make grinding noises are all fine. Working units in good condition may be donated or resold, while broken ones go straight to appliance and scrap metal recyclers. Mismatched pairs, rusty cabinets and missing knobs are no problem either. Older units that rusted or leaked are fine and go straight to scrap metal recycling.

Can you remove a washer and dryer from a basement?

Yes. Basement laundry rooms are one of the most common pickups. Crews use proper lifting technique and equipment to bring each unit up the stairs safely, protecting railings, walls and steps along the way. If the stairway is especially narrow, steep or has a tight turn at the top, mention it when you book so the right size crew is sent. Clearing laundry baskets and detergent shelves from the stairway helps the crew move quickly.

Can you separate a stacked washer and dryer?

Yes. Stacked units are joined with a stacking kit, and the crew will separate them before moving so each unit can be carried safely. All-in-one laundry centers, where the washer and dryer are built as a single unit, are moved together. Make sure the water and power are disconnected, and gas is capped for gas models, before the crew arrives. Your installer can usually reconnect the new pair once the stacked units have been removed.

What happens to my old washer and dryer?

Working units in good condition may be donated or resold. Everything else goes to appliance and scrap metal recyclers, where steel cabinets, drums, copper wiring and motors are separated and recovered. Concrete counterweights from front-load washers and plastic parts that can't be recycled are disposed of properly. That keeps most of the weight of a washer or dryer out of the landfill. Recycling also recovers copper wiring and motors, which are valuable scrap materials.

Ready when you are

Clear out the laundry room.

Tell us what's going and a local crew will haul it away, often the same or next day.

Book laundry appliance removal